FTDI Community

Please login or register.

Login with username, password and session length.
Advanced Search  

News:

Welcome to the FTDI Community!

Please read our Welcome Note

Technical Support enquires
please contact the team
@ FTDI Support


New Bridgetek Community is now open

Please note that we have created the Bridgetek Community to discuss all Bridgetek products e.g. EVE, MCU.

Please follow this link and create a new user account to get started.

Bridgetek Community

Show Posts

You can view here all posts made by this member. Note that you can only see posts made in areas to which you currently have access.

Topics - perrizozach

Pages: [1]
1
Hello,

I'm trying to get ANY project to run on my VNC2 debugger, but it appears the program doesn't even begin to run. When I select "start", the debugger LEDs flash normally, but when I create a breakpoint it never halts. Even if the breakpoint is the first executable action, the debugger doesn't halt. Is this a common error?

Any advice helps.

Thanks

2
Hello,

I'm trying to set up my debugger interface with Vinculum ii, but the IDE "debugger interface" section says "disconnected", and when I scan for devices it searches for about two full seconds before returning "no devices found".

After installing a driver, my computer recognizes the board I've plugged in is an FTDI device (even though it is connected through one USB port, my device manager reads that there is an FTDI device on two separate COM ports).

The board is set up with the 48 pin daughter card, and receives power from my computer. When I scan for devices in the debugger section, the board's Tx LEDs blip faintly (all of the top LEDs light up brightly when I turn on the board, but other than that don't turn on save for this occurrence).

Any suggestions are appreciated.

Pages: [1]