Hi, everybody.

For VNC1L, FTDI send me "VncFwMod.exe" software and VDAPFUL_V03_69.ROM.
I had readen this ROM file with "VncFwMod" software and had modified UART rate and version number, then reprogram the VNC1L by used FT-Prog software
All was ok.

Today, FTDI don't send me a VDAPFUL for VNC2 so I must compile V2DAP project included in toolchain V2.02 SP2 under VNC1L directory.
Then I program VNC2 by sending V2DAP.ROM by FT-Prog.exe.

Problem : when I communicate with VNC2 throught the PC terminal, VDAP2.ROM don't work like préviously with VNC1L
and when I send some commands (example : RDF after OPR ), VNC2 send too many characters and don't give control.

First, is it possible to send me ROM file to communicate throught UART to read and write files on USB key like "VDAPFUL_V03_69.ROM" file but for VNC2 please (and full project) ?

Then, is there software version "VncFwMod.exe" for VNC2 chip (to change baudrate and ROM file VERSION) ?

Many thanks for your help.