FTDI Community

Please login or register.

Login with username, password and session length.
Advanced Search  

News:

Welcome to the FTDI Community!

Please read our Welcome Note

Technical Support enquires
please contact the team
@ FTDI Support


New Bridgetek Community is now open

Please note that we have created the Bridgetek Community to discuss all Bridgetek products e.g. EVE, MCU.

Please follow this link and create a new user account to get started.

Bridgetek Community

Author Topic: FT906L USB Connection  (Read 8169 times)

Yunuce

  • Newbie
  • *
  • Posts: 10
    • View Profile
FT906L USB Connection
« on: July 02, 2019, 11:51:28 AM »

Hello everyone,

I use FT906L and i want to use USB device connection for send commands and power supply.
Do i connect VUSB and HREF to ground?
But i wonder that i should connect pullup/down resistor or not?
Is there any schematics about that and there is data line 22k resistor in some documents where should i connect resistor?
Some microcontroller need a RTC Oscillator because USB don't run, FT906L needs or not RTC?

Best regards.
« Last Edit: July 03, 2019, 09:07:11 AM by Yunuce »
Logged

FTDI Community

  • Administrator
  • Hero Member
  • *****
  • Posts: 891
    • View Profile
Re: FT906L USB Connection
« Reply #1 on: July 03, 2019, 10:11:16 AM »

Hello,

We recommend to use our evaluation modules below as a guide for this.

https://brtchip.com/m-ft9xx/

The MM900EVxA have both USB device and host and so you can find examples of how to connect them and the crystal circuitry in the schematics at the end of the document.

Best Regards, FTDI Community
Logged