FTDI Community

Please login or register.

Login with username, password and session length.
Advanced Search  

News:

Welcome to the FTDI Community!

Please read our Welcome Note

Technical Support enquires
please contact the team
@ FTDI Support


New Bridgetek Community is now open

Please note that we have created the Bridgetek Community to discuss all Bridgetek products e.g. EVE, MCU.

Please follow this link and create a new user account to get started.

Bridgetek Community

Author Topic: FT230XS Board to Board communication  (Read 12152 times)

kalesha

  • Newbie
  • *
  • Posts: 4
    • View Profile
FT230XS Board to Board communication
« on: September 29, 2022, 08:22:09 AM »

I have two boards which has FT230XS and interfaced with microcontroller and now I want to communicate those two boards using FT230XS as bridge

My doubt is how to connect two FT230XS signals (DP DM VCC GND) from one board to other board, we tried connected usb-usb cable and we drive voltage over VCC and found not communicating each other

Both boards working individually when connected to PC.
Logged

FTDI Community

  • Administrator
  • Hero Member
  • *****
  • Posts: 892
    • View Profile
Re: FT230XS Board to Board communication
« Reply #1 on: September 29, 2022, 04:31:04 PM »

Hello,

FT230XS is a USB device and must be connected to a USB Host.

So you can't connect two of them together like that with the USB signals.

Best Regards,
FTDI Community
Logged

kalesha

  • Newbie
  • *
  • Posts: 4
    • View Profile
Re: FT230XS Board to Board communication
« Reply #2 on: September 30, 2022, 06:23:48 AM »

Is there any alternate way to communicate two boards like in one board USB device and other board has USB host IC so that the boards can communicate. Suggest one USB Host IC
Logged

FTDI Community

  • Administrator
  • Hero Member
  • *****
  • Posts: 892
    • View Profile
Re: FT230XS Board to Board communication
« Reply #3 on: September 30, 2022, 04:34:29 PM »

Hello,

Does you Microcontroller already have UART or say I2C ports?
If so you could consider that method rather than using FT230X which would complicate your design by adding an additional USB Host.

If you require a USB Host capable of hosting FTDI devices then the best solution I can recommend is FT90x from our sister company Bridgtek.

See AN 360 FT9xx Example Applications section 2.23.6 USBH Example FT232.

Take a look at FT90x UART to FT232 Host Bridge, there is already a software example which can host FTDI devices including FT230X.
A video has been created which demonstrates this:

https://youtu.be/_vwOKFaOcJI

Bridgetek provide FT9xx Development Modules and a free FT9xx Toolchain for custom application development.

If you require support with this IC then please contact Bridgetek for support:
https://brtchip.com/ic-module/contact-us/

Best Regards,
FTDI Community
Logged