1
General Discussion / Re: Ft260q-t instead of ft232r
« on: October 05, 2021, 01:32:46 AM »
Hello,
According to datasheet, DCNF0 pin should be set to high and DCNF1 set to low in order to enable UART communication. Is there any other configuration I should consider to allow the IC to act as TTL-232R cable converter?
Thank you,
According to datasheet, DCNF0 pin should be set to high and DCNF1 set to low in order to enable UART communication. Is there any other configuration I should consider to allow the IC to act as TTL-232R cable converter?
Thank you,