Hello,

It sounds like you have corrupted the project with the changes that you have made.
It might be worthwhile re-downloading the project and starting again and taking care with each change you make.
You could also start with a new project in Eclipse and add your own code/structure. See section 3.1 Creating a new project in AN_325 FT9xx Toolchain Installation Guide.

AN_398 was never released. Instead the information is included in section 2.34 Datalogger Feature of AN_365 FT9xx API Programmers Manual.

AN_415 Ethernet to GPIO does indeed use the datalogger feature to store information in EEPROM.

Webpage images could be stored on the SD Card to reduce space or the webpage images could be removed for test purposes.
the Ethernet stack lwip is most likely taking up a lot of space. There should be more information online about reducing this size. The alternative would be to develop your own Ethernet stack.

Note the Bridgetek Community is now open.
We have created the Bridgetek Community to discuss all Bridgetek products e.g. EVE, MCU.
Please follow this link and create a new user account to get started.

Bridgetek Community

Best Regards,
FTDI Community

Hello Logan,

Yes the following signals are all connected to the programmer module via CN7 which are then connected to PortB of the FT4232H on the UMFTPD2A, so I can see why there would be some contention on the SPI lines:

SPIS0_CLK/GPIO36
SPIS0_SS/GPIO37
SPIS0_MOSI/GPIO38
SPIS0_MISO/GPIO39

As I have mentioned in my emails, please check out the SPI master to SPI slave example in AN_360 FT9xx Example Applications which can be used as a reference.

Best Regards,
FTDI Community

Hello,

I assume you mean 3.1.2?
There is a new version slated for release by the end of the month, I believe this will resolve your issue.

Best Regards,
FTDI Community

Hello,

Thanks for sending a follow up to your question explaining the workaround, I'm sure this will be a good resource for the Community.

Many thanks,
FTDI Community

Hello,

I see that you have also contacted email support where we will deal with your issue and post an outcome here.

Regards,
FTDI Community

Hello,

I'm working with you via email on this.

Please post the solution here which will benefit other users.

Best Regards,

FTDI Community

Hello,

I will need to double check with the development team if it is possible to send host commands to a Cleo board in such a manner, as the FT900 on the Cleo is programmed with a custom firmware which expects Cleo.xxx() commands.

Best Regards,
FTDI Community

Hello,

Can you please try using Ft_Gpu_HostCommand(phost,0x43); and let me know how you get on?

Best Regards,
FTDI Community